|
|
|
4 Reviews from ryan77.
|
|
 | |  |
|
| 3" Body Lift Kit by Performance Accessories |
| Quality: |
| 4 |
| Features: |
| 5 |
| Installation: |
| 3 |
| Appearance: |
| 5 |
| Overall Rating: |
| 4 |
|
| somewhat happy |
| Written on November 10, 2007 02:34:58 PM |
| |
| I did like that I was able to get larger tires w/o tire rub. What I didn't like is now I hear noises when the body of my truck goes around corners or goes over bumps because it creeks. We tried everything to eliminate it but it is what it is. Make sure you buy the gap guards because looking under the bed and seeing a 3" gap is not cool, besides the frame obviously stays where it is since your raising the body and not the suspension so the frame shows as well, more than it normally would. Bottom line...Overall, I gave it a four, I am happy but I don't like the extra noises. I am also happy to have gotten the gap gaurds. It sure does make my truck look higher. Good luck, you'll need two guys to help you out and about 6-8 hours for installation. |
|
|
| Ultimate LED Light Kits |
| Quality: |
| 5 |
| Features: |
| 5 |
| Installation: |
| 5 |
| Appearance: |
| 5 |
| Overall Rating: |
| 5 |
|
| Too cool |
| Written on November 10, 2007 02:24:36 PM |
| |
| I originally bought two of these for the inside of my Chevy truck and was thrilled with them. I decided to buy four more to place under the fender. I am amazed!! I did buy the blue ultimate LED's and in my state it is against the law, but I just turn them off when I see the coppers coming. Anyways, they are very bright and they light up the entire wheel, rim and even the ground. I like it much better than original underbody kits. I always see people rubber-necking when I drive by because it's just too cool not to stare. You will be happy....and they are very, very bright!! |
|
|
| Spark Plugs by E3 |
| Quality: |
| 3 |
| Features: |
| 3 |
| Installation: |
| 3 |
| Appearance: |
| 4 |
| Overall Rating: |
| 3 |
|
| All talk and no walk..... |
| Written on November 10, 2007 02:01:19 PM |
| |
| This spark plug is no different. The features are so small like the horsepower gain and the amount you'd save at the pump, it's more a mental thing because you read this hype and think it's going to make a difference and the only change you get is what's left over after paying such a large amount for a plug thats no different than the rest, that's only my opinion. Stick to Champion or NGK. Thanks. |
|
|
| Powr-Flo Mass Air Sensors by JET |
| Quality: |
| 5 |
| Features: |
| 5 |
| Installation: |
| 5 |
| Appearance: |
| 5 |
| Overall Rating: |
| 5 |
|
| Mr. Chevy HorsePower |
| Written on November 01, 2007 02:55:45 PM |
| |
| Well Well, first off I gave this product a high rating because the mass air flow sensor is a great product overall. What makes me unhappy is that this does not work with after market computer upgrades like the Hypertec Power Programmer III. It advertises that it does but it doesn't. After you install this product Jet will not accept it back despite what the return policy is. I installed this and the "check engine light" came on, once I took it off and reset the negative battery cable, it was fine again. After spending almost $400 bucks this mass air flow sensor is nothing but a paper weight. I don't think any less of the sensor or the company but it's important for future buyers to know this. If you don't have an after market computer upgrade, then this is the MAS for you. This works great with, Airaid "classic" air intake, Airaid throttle body spacer and dual super44 flowmaster exhaust with 3.00" stainless steel tubing. Good luck. |
|
|
| |
 | |  |
|
|