|
|
|
4 Reviews from scoobysnax.
|
|
 | |  |
|
| Catch-All Carpet Floor Mats |
| Quality: |
| 5 |
| Features: |
| 4 |
| Installation: |
| 5 |
| Appearance: |
| 5 |
| Overall Rating: |
| 5 |
|
| Great Mats - Look better than factory option |
| Written on November 01, 2007 09:08:55 AM |
| |
| Purchased #647243 floor mat set for my 07 Ford Escape. The web site says this set doesn't fit my vehicle, but it's wrong. This is the correct set, and the mats fit perfectly. I didn't want to use the carpet anchors, so I just capped off the holes in the front mats with the included caps. Too early to tell how they will hold up this winter, but so far, so good. |
|
|
| In-Channel Ventvisors by Auto Ventshade (AVS) |
| Quality: |
| 2 |
| Features: |
| 2 |
| Installation: |
| 3 |
| Appearance: |
| 3 |
| Overall Rating: |
| 2 |
|
| AVS Ventvisors not the best for 07 Escape |
| Written on September 06, 2007 02:38:13 PM |
| |
| The AVS visors I purchased for my 07 Escape were very thin and not very wide. One of the front visors had a crack it, so it seems like they are easy to break. Go with the EGR in-channel visors if they are available for your vehicle. |
|
|
| In-Channel Slimline Window Visors by EGR |
| Quality: |
| 5 |
| Features: |
| 5 |
| Installation: |
| 5 |
| Appearance: |
| 5 |
| Overall Rating: |
| 5 |
|
| EGR Slim Line Visors for 07 Escape |
| Written on September 06, 2007 02:34:15 PM |
| |
| These EGR vent visors are much better quality than the AVS visors I originally purchased. The AVS visors were made of thin plastic and one of the front window visors already had a crack in it. The EGR visors are much thicker and wider. The front visors installed quickly and are VERY tight in the window channel. I had to roll the window up and down over a couple of days to get the window operating normally. The rear visors come with double-sided tape and metal brackets to hold the visors in place. The brackets fit behind the weather stripping on each side of the window and hold the visors up with two plastic rivets. I used the double-sided tape as well to keep the visor tight against the top of the window channel. Took about 10 minutes to install all four on my 07 Escape and they look great. No tools needed. |
|
|
| AeroWrap XE Hood Guard |
| Quality: |
| 5 |
| Features: |
| 5 |
| Installation: |
| 5 |
| Appearance: |
| 5 |
| Overall Rating: |
| 5 |
|
|
| Written on September 06, 2007 02:19:53 PM |
| |
| The Aerowrap XE hood guard was easy to install on my 07 Escape. No drilling required. Attaches to factory mounting holes with included screws and screw plugs. Made of sturdy plastic. |
|
|
| |
 | |  |
|
|